Displaying The Monitor Status Page - Sony BVM-E250 Operation Manual

3
Press the ENTER (Ent) button.
The data is saved in the "Memory Stick".
Notes
• Use the controller with software version 1.6 or higher for
data saving, copying and deleting using the "Memory
Stick".
• Data saving, copying and deleting using the "Memory
Stick" is not available on BKM-15R or BVM-A14F5.
• Data copying from the BVM-A, PVM-L or BVM-L
series monitor is not available.
Displaying the Monitor
Status Page
When Status has been assigned to a function button of the
controller, the setting status, display mode and input signal
information of the currently displayed video signal are
displayed on the monitor status pages.
For how to assign a function to a function button, see
"Assigning a Function to a Function Button" (page 97).
Note
To assign Status to a function button of the controller, use
the controller with software version 1.6 or higher.
1
Press the Status button on the controller to set it to On.
Page 1/3 of STATUS display is displayed.
2
Select the STATUS page you wish to view using the
UP/DOWN button on the controller.
You can select the page from among 1/3, 2/3 and 3/3.
For the contents of each page, see below.
To cancel the display of the STATUS page
Press the Status button on the controller again.
Page 1/3
Information on the setting status of the input signal and the
display mode is displayed.
STATUS (Input / Display Mode)
CH: 01 "PROG1"
Detected Signal: 1080/60I
Format: 4:4:4 RGB 10bit
Input Por t: Option1/Input1
RGB Range: Limited
1080I/PsF: 1080I
Scan Mode: Native Aspect Correct
Aspect Mode: 16:9
Interlace Display: ON
CH: Displays the currently selected channel number and
channel name.
Detected Signal: Displays the signal system whose format
is detected.
Format: Displays Format set in the Channel
Configuration menu.
Input Port: Displays Input Port and Input No. set in the
Channel Configuration menu.
v
1/3
V

Displaying the Monitor Status Page

95