Divar XF
Note:
Tips for troublefree motion detection:
–
–
–
6.7
Event
Use the Event menu to specify the desired behavior for an active contact input, detected
motion, or video loss. The general behavior of events is also set here. Each of the six profiles
has a General, Contact, Motion and Video loss tab.
Figure 6.8 Event menu - General
6.7.1
General
Auto acknowledge alarms
–
Alarm dwell time
–
Bosch Security Systems
The size of a motion area influences the sensitivity in this area. A small motion area
should be used to detect small objects (high sensitivity); a large area should be used to
detect large objects (low sensitivity).
Noise in the camera image can create false motion events, especially when detecting
small objects. Make sure the camera has been set up correctly and enough lighting is
available for the camera to obtain a noise-free image.
Ensure that the camera is mounted so that it does not shake due to wind or other
influences.
Enable when alarms should be acknowledged automatically. By default, an alarm must be
manually acknowledged.
Set between 1 and 59 seconds to select the period during which the output relay and the
beeper remain active after activation.
Installation manual
Advanced configuration menu | en
F.01U.135.429 | 2.5 | 2009.08
63