Adjusting Zoom And Focus; Mounting The Camera - JVC VN-T216U Instructions Manual

Adjusting Zoom and Focus

Mounting the Camera

Ÿ
Loosen the zoom lever (D) / locking screw by turning it counter-clockwise.
Ÿ
Rotate the zoom ring to achieve the desired picture.
Ÿ
Loosen the focus lever (E) / locking screw by turning it counter-clockwise.
Ÿ
Rotate the focus ring to adjust the focus.
Ÿ
If re-adjustment is necessary, repeat the steps above.
Ÿ
Retighten the zoom lever( D) / locking screw and the focus lever (E) / locking
screw.
Caution Retighten the locking screws to prevent loss of adjustment.
Ÿ
Place the mounting template (supplied) on the mounting surface and mark the
holes.
Ÿ
Drill two holes, and then insert the screw anchors into the holes.
Ÿ
Take off the camera housing.
Ÿ
Connect the Safety Wire (fall prevention wire, not supplied ) to the ceiling.
A
B
C
E
D
12