Adjusting Zoom And Focus; Mounting The Camera - JVC VN-T216U Instructions Manual

Adjusting Zoom and Focus

Mounting the Camera


Loosen the zoom lever (D) / locking screw by turning it counterclockwise.

Rotate the zoom ring to achieve the desired image coverage.

Loosen the focus lever (E) / locking screw by turning it counterclockwise.

Rotate the focus ring to adjust the appropriate focus.

If re-adjustment is necessary, repeat the steps above.

Retighten the zoom lever（D）/ locking screw and the focus lever (E) / locking
screw.
Securely retighten the locking screws to prevent loss of
Caution
adjustment.

Place the mounting template (supplied) on the mounting surface and mark the
holes.

Drill two holes, and then insert the screw anchors into the holes.

Take off the camera housing.

Connect the Safety Wire (fall prevention wire, not supplied) to the ceiling.

Secure the camera bottom case (1) to the wall/ceiling with the TP4 x 15 mm
tapping screws, supplied.

Insert the power cable, LAN cable and Audio cables.

Adjust the view angle (zoom, focus, and Horizontal Rotation).
A
B
C
E
D
13