Connecting The Power Wiring; Adjusting The Camera Position - JVC VN-T216U Instructions Manual

Connecting the Power Wiring

Adjusting the Camera Position

Connect the power supply cable to the power connectors.
If using a DC supply, make sure the polarity is correct.
Caution Incorrect connection may cause malfunction and / or
damage to the camera.
Connectors and field wiring terminals for external Class 2
circuits provided with marking indicating minimum Class
Note
of wiring to be used. Class 2 shall be marked adjacent
to the field wiring terminals
Select one of the following options.

For DC12V
Connect 12 V (-) to terminal =DC12V-
Connect 12 V (+) to terminal =DC12V+

For AC24V
Connect 24 V (~) cables to terminals ~AC24V.

PoE
Connect the network cable to the RJ45 terminal using a switch.
The dome camera has three axes for positioning the camera. While monitoring the
picture on the monitor, adjust the camera position as follows:

Pan Adjustment (A) For Wall Mount and Tilted Ceilings: Rotate the lens base
(maximum 360°) until you are satisfied with the field of view.

Horizontal Rotation (B) Rotate 3D assembly in the base. Do not turn
assembly more than 360°as this assembly may cause the internal cables to
twist and disconnect or break.

Tilt Adjustment (C) After loosening the thumbnuts, position the camera as
desired, then finger –tighten the thumbnuts to set the position.
Do not turn the lens more than 360° as this may cause internal
Caution
cables to disconnect or break.
12