Advertisement
To verify voice dial-peer configuration, enter the privileged EXEC show dial-peer voice
Step 2
command. The following text is sample output from the show dial-peer voice command:
Router# show dial-peer voice
VoiceEncapPeer1
tag = 1, destination-pattern = '4002',preference = 0,
Admin state is up, Operation state is up
type = pots, prefix = '',
session-target = '', voice-port = 1/1
VoiceOverATMPeer2
tag = 2, destination-pattern = '4001',preference = 0,
Admin state is up, Operation state is up
type = voatm, session-target = 'ATM0'
nsap '47.0091810000000050E201B101.00107B09C6ED.FE',
VoiceEncapPeer3
tag = 3, destination-pattern = '4003',preference = 0,
Admin state is up, Operation state is up
type = pots, prefix = '',
session-target = '', voice-port = 1/1
You can also enter a dial-plan number in order to learn more about a voice dial peer with
Step 3
the show dialplan number dial string command, as shown in the following example:
router# show dialplan number 5558809
Macro Exp.: 3388809
VoiceEncapPeer9
information type = voice,
tag = 9, destination-pattern = '5558809',
answer-address = '', preference=0,
group = 9, Admin state is up, Operation state is up,
incoming called-number = '', connections/maximum = 0/unlimited,
application associated:
type = pots, prefix = '',
session-target = '', voice-port = '1/9',
direct-inward-dial = disabled,
register E.164 number with GK = TRUE
Connect Time = 0, Charged Units = 0,
Successful Calls = 0, Failed Calls = 0,
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "",
Last Disconnect Text is "",
Last Setup Time = 0.
Matched: 5558809
Target:
fwd-digits = 0,
fwd-digits = 0,
Digits: 7
Voice over ATM Switched Virtual Circuits on the Cisco MC3810 15
Verifying Voice Ports and Voice Dial Peers
Advertisement
