Subscriber Traffic Processor IP Ranges
How to Remove Mappings from a Specified IP Range
From the SCE(config if)# prompt, type
Step 1
ip-address/mask and press Enter.
The remove-subscriber-mappings option is not applicable to this command.
How to Import and Export TIRs
Use these commands to import TIR definitions from a csv file and to export TIR definitions to a csv file.
•
•
•
•
About TIR csv Files
Following is the format of the csv file:
range name, ip-address/mask-length, target-TP
•
•
•
•
Options
The following option is available:
•
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
9-34
About TIR csv Files, page 9-34
Options, page 9-34
How to Import TIRs from a csv File, page 9-35
How to Export TIRs to a csv File, page 9-35
range name — The name of the to which the IP addresses will be assigned
ip-address/mask-length — individual IP address of range of IP addresses indicated by IP
address/mask
target-TP — traffic processor to which the specified range will be assigned
remove-subscriber-mappings — When importing TIR definitions, by default, if subscriber
mappings already exist for any specified IP range, those IP ranges will not be updated by the import.
However, you can use this keyword to specify that any existing subscriber mappings in the IP range
should be removed.
In this case the command will execute successfully even if subscriber mappings exist.
filename — the name of the csv file.
no subscriber mappings included-in IP-range
Chapter 9
Managing Subscribers
OL-7827-12