Dell DR4000 Owner's Manual page 34

Message
Unable to launch
System Services
image. System
halted!
Unexpected
interrupt in
protected mode.
Unsupported CPU
combination
Unsupported CPU
stepping
detected.
Unsupported DIMM
detected. The
following DIMM
has been
x
disabled:
34
About Your System
Causes
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost due
to system board replacement.
The iDRAC6 Enterprise card
flash memory or BMC SPI
flash may be corrupted.
Improperly seated memory
modules or faulty
keyboard/mouse
controller chip.
Processor(s) is not supported
by the system.
Invalid memory
configuration. The system
runs but with the specified
memory module disabled.
Corrective Actions
Restart the system and
update the Lifecycle
Controller repository to the
latest software to restore full
functionality. See the
Lifecycle Controller User
Guide for more information.
Restore the flash memory
using the latest version on
support.dell.com. See the
Integrated Dell Remote
Access Controller 6
(iDRAC6) User Guide for
instructions on performing a
field replacement of the
flash memory.
Reseat the memory modules.
See "Troubleshooting
System Memory" on
page 129. If the problem
persists, see "Getting Help"
on page 149.
Install a supported processor
or processor combination.
See "Processors" on page 95.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 76.