Installing An Idrac6 Express Card - Dell DR4000 Owner's Manual

Installing an iDRAC6 Express Card

CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 60.
3 If installed, remove all expansion cards from expansion-card riser.
"Removing an Expansion Card" on page 82.
4 Insert the notch on the
Express card into the clip on the system board.
5 Align the front edge of the card with the connector on the system board.
See Figure 6-1 for the location of the connector.
6 Press the card down until it is fully seated. See Figure 3-16.
When the front of the card is fully seated, the plastic standoff tab snaps
over the edge of the holder.
Integrated Dell Remote Access Controller 6 (iDRAC6)
Installing System Components
91