Table of Contents
Advertisement
8. When writing of the firmware is completed, the screen appears as shown below. (Fig. 6)
Click [OK]. (Fig. 6)
9. Click [Exit] to end FlashSta.exe. (Fig. 6)
Start up the self-diagnostic function of this unit and select the "1. FIRMWARE VERSION" menu.
10. Using the sub-menu, have the firmware version and checksum displayed, and then check that they are the same
as written ones.
*
When the firmware version and checksum are different from written ones, perform the "UPDATING FIRMWARE"
procedure all over again.
11. Disconnect the power cable of this unit from the AC outlet.
●
Initializing of this unit
*
After updating firmware, be sure to initialize this unit.
Start up the self-diagnostic function of this unit and select the "B. FACTORY PRESET" menu. (See "SELF-DIAGNOSTIC
FUNCTION")
Select the "PRESET RSRV" (Initialization reserved) and turn off the power to this unit.
PRESET INHIBIT (Initialization inhibited)
Fig. 6
1-1 Firmware version
1-2 Checksum
PRESET RESERVED (Initialization reserved)
CRX-330/NS-BP100
19
Hide quick links:
Advertisement
Table of Contents
