Dell Streak User Manual page 72

NOTE:
To connect to a network protected by Wired Equivalent Privacy
(WEP), WPA (Wi-Fi Protected Access), WPA2, or WPS (Wireless Protected
Setup), you must enter the WEP/WPA/WPA2/WPS security key to obtain
authorized access to the network. The next time your device connects to
a previously accessed secured wireless network, you will not be asked to
enter the WEP/WPA/WPA2/WPS key again, unless you reset your device
to its factory default settings.
NOTE:
Your device has the ability to maintain a constant Internet
connection through Wi-Fi or mobile networks (GPRS, EDGE, 3G, or
HSPA). However, Wi-Fi connection has priority over mobile network
connection if both are available.
To check the current Wi-Fi network connection
From the status bar:
When your device is connected to a wireless network, the Wi-Fi icon
in the status bar indicates the signal strength (number of bands
that light up). If Wireless & networks→ Wi-Fi settings→ Network
notification is enabled, this icon
device discovers an accessible Wi-Fi network within range.
From the Wi-Fi network:
1 Touch the Home button
Wireless & networks→ Wi-Fi settings.
2 Touch the Wi-Fi network that the device is currently connected to
(labeled Connected). A window opens displaying the Wi-Fi
network's name, status, security info, signal strength, link speed,
and IP address.
NOTE:
If you want to disconnect the Wi-Fi network from your device,
touch Forget on this window. You will need to configure the Wi-Fi
settings again if you want to restore connection to this wireless network.
72
Internet
appears in the status bar as the
→ Menu button → Settings→