Imprinter Selection - Fujitsu 5900C - fi - Document Scanner Operator's Manual
Image scanner
Hide thumbs
Also See for 5900C - fi - Document Scanner:
- Getting started (30 pages) ,
- Brochure & specs (2 pages) ,
- Supplementary manual (4 pages)
Table of Contents
Advertisement
8.16 Imprinter Selection
You can specify which imprinter to use; Pre-imprinter or Post-imprinter, if you already have installed these
options.
Configure the settings for the Imprinter Selection as follows:
1.
Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page
2.
Select the "Imprinter Selection" setting on the [Device Setting 2] tab.
3.
Select the Imprinter to use.
Normal (obey Host specification): Complies with the scanner driver setting.
Forcibly select Pre-imprinter:
Forcibly select Post-imprinter:
HINT
192
8.16 Imprinter Selection
166.
Pre-imprinter is forcibly used to print unless directed by
the scanner driver.
Post-imprinter is forcibly used to print unless directed by
the scanner driver.
For details on the specifications of the imprinter, refer to
page 195.
"9 OPTIONS" on
Advertisement
Table of Contents
