Preparations - Panasonic WV-CW504SE Installation Manual

Preparations

When installing the camera on a wall or a ceiling, there are two methods as specified below.
(+ Next page)
• Using a two-gang junction box
• Using the camera mount bracket (accessory)
Refer to all work related to the installation of this product to qualified service personnel or system
installer.
Important:
• Prepare the mounting screw according to the material of the area where the camera attach-
ment (accessory) is to be installed. In this case, wood screws and nails should not be used.
For mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4)
for securing.
(Recommended tightening torque M4: 1.6 N·m)
• When using the provided camera attachment, make sure that either of the arrow marks faces
upward.
• Required pull-out capacity of a single screw/bolt is 196 N or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall
be sufficiently reinforced.
• When using an optional mounting bracket, refer to the operating instructions of the bracket in
use.
The mounting conditions of the camera mount bracket are described as follows:
Installation Applicable mount
place bracket
Ceiling/wall (Two-gang junction box)
Ceiling/wall Camera mount bracket
(approx. 350 g)
Ceiling WV-Q169
(approx. 700 g)
* Make sure that the installed mount bracket can support more than 5 times of the weight of the
camera.
14
Recommended Number
screw of screw
M4 or equivalent
M4 or equivalent
–
Minimum pull-out
strength
(per 1 pc.)
4 pcs. 196 N
4 pcs. 196 N
– *