Rear View; Bottom View - Panasonic WV-SC385 Installation Manual

Rear view

12 V DC power supply terminal
About the [INITIAL SET] button
After turning off the power of the camera, turn on the power of the camera while holding down this button, and wait for
around 5 seconds or more without releasing this button. Wait around 3 minute after releasing the button. The camera will
start up and the settings including the network settings will be initialized. Before initializing the settings, it is recommended
to write down the settings in advance. Note that the preset position settings and the CRT key (SSL encryption key) used
for the HTTPS protocol will not be initialized.

Bottom view

Important:
• Use this hole only when the camera is to be installed on desktop using a tripod.
• Do not use this hole to mount on the ceiling since the fall prevention measure is unavailable.
14
Access indicator
(blinking at accessing)
10BASE-T/
Link indicator
100BASE-TX
LINK
(lighting at linking)
Network connector
INITIAL SET button
Cable guide
Audio output connector
POWER
ACT INITIAL EXT I/O
AUDIO OUT
MIC/LINE IN MONITOR OUT
SET
12V IN
4 3 2 1
Screw hole for a tripod
(1/4-20 UNC for tripod)
Monitor out connector
for adjustment
Safety wire holder
Microphone/line input connector
External I/O terminals