Function Menu —Map Settings (continued)
Menu items
Vehicle Position
Clear User Memory
Restore Factory Settings
Reset Calibration Data
Access Navi SD
Startup Message*
Shutdown Message*
Traffic Service
1
*
Selectable only when at least one place is registered.
2
*
You cannot use Cyrillic characters for the message.
For entering the characters, ☞ page 28.
3
*
Selectable settings, [reference page]
If you find your current position displayed on a wrong place on the map,
use this setting to correct your position.
• To change your position, move the cursor to the position where you
want to set as current position and press [OK], then adjust the direction
by pressing [ ]/[ ] and press [OK].
: Initializes the list of your favorite points. ☞ [24]
1
Favorite*
: Initializes the list of previous destinations and via points. ☞
1
Previous*
[36]
: Initializes the registration of your home. ☞ [24]
1
Home*
Initializes all your settings.
• When you press [Restore], a confirmation message appears. Press [Yes]
to confirm the operation. Press [No] to cancel.
The Navigation System is gradually optimized by automatic calibration.
Reset the calibration data in the following cases:
• When you reinstall the unit in another car.
• When you replace or rotate the tires.
Once this is carried out, the calibration data is cleared.
• When you press [Reset], a confirmation message appears. Press [Yes]
to confirm the operation. Press [No] to cancel.
Select this to update your map database using an SD card.
• When you press [Open the Front Panel], the front panel opens. Press
[Cancel] to cancel the operation.
• For details about updating your unit, visit <http://www.jvc-exad.com>
(English website only).
2
Edit the voice message at startup/shutdown of the System.
• To edit the message, press [Edit], enter the message, then press [OK].
2
You can listen to the edited message by pressing [Test].*
Subscribe to traffic services. ☞ [47]
The procedure for setting an item is shown on page 16.
52
Initial:
Underlined
3