If You Printed Two 8 × 10-Inch Or 5 × 7-Inch Cover Pages - Epson S041885 - Storyteller Photo Book Creator Manual

If You Printed Two 8 × 10-Inch or 5 × 7-Inch Cover Pages
Note: Avoid touching the glossy surface of the StoryTeller paper as much as possible to avoid fingerprints.
1
Locate the adhesive strips that came with your photo book.
2
Turn your front cover page over.
3
Remove the backing from four adhesive
strips and adhere a strip to each side of
the cover, as shown.
4
Place the front cover page on the front of
your book, lining it up with two sides of
the book to make sure it's even. (Check
the pages inside to make sure the cover is
right side up!) Then press down gently.
5
Repeat these steps with the back cover
page.
Place the adhesive
strips on the back of the
cover page
If You Printed Two 8 × 10-Inch or 5 × 7-Inch Cover Pages
Place the front cover page on
the front of your book
89