Table of Contents
Advertisement
Troubleshooting (Basic)
Display
The external display does
not work normally.
<Only for model with GPS>
The cursor cannot be con-
trolled properly.
Touch Pad / Touchscreen (only for model with touchscreen)/Dual Touch (only for model with dual touch)
The cursor does not work.
Cannot input using the touch
pad.
<Only for model with touch-
screen>
Cannot input using the
touchscreen.
Cannot point the correct
position using the included
stylus/digitizer pen.
32
If the external display does not support the power saving function, it may not work nor-
mally when the computer enters the power saving mode. Turn off the external display.
Operate the following steps.
A Set [GPS] to [Disable] in the [Advanced] - [Serial Port Settings] of the Setup Utility.
F10
B Press
and select [Yes] at the confi rmation message, and press
The computer will restart.
C Log on to Windows as an administrator.
D Click
(Start) and input "c:\util\drivers\gps\GPSVista.reg" in [Search programs and
Enter
fi les], and press
E Click [Yes], click [Yes] and click [OK].
Then restart the computer.
F2
F Press
while [Panasonic] boot screen is displayed.
G Set [GPS] to [Enable] in the [Advanced] - [Serial Port Settings].
F10
H Press
and select [Yes] at the confi rmation message, and press
When using the external mouse, connect it correctly.
Restart the computer using the keyboard.
Press
and press
Press
,
, and
to select [Restart].
U
R
If the computer does not respond to keyboard commands, read "No response"
(
page 33).
Set [Touch Pad] to [Enable] in the [Main] menu of the Setup Utility.
The drivers for some mice may disable the touch pad. Check your mouse's operating
instructions.
Set [Touchscreen Mode] to [Auto] or [Tablet] in the [Main] menu of the Setup Utility.
Set [Touchscreen Mode] to [Auto] or [Touchscreen Mode] in the [Main] menu of the
Setup Utility.
<Only for model with touchscreen>
Perform the touchscreen calibration (
<Only for model with dual touch>
Perform the digitizer calibration and Touchscreen calibration (
Use the included digitizer pen.
On the Windows logon screen or the Welcome screen, you may not be able to point the
correct position using the included digitizer pen. Use the keyboard or the touch pad to
log on.
.
twice, and press
to select [Restart] and press
page 18).
Enter
.
Enter
.
.
Enter
page 19).
Advertisement
Table of Contents
