NEC 870 - SuperScript B/W Laser Printer Network Quickstart page 3

Installing the 870 NIC
A
Turn off the printer, remove the
power cord from the rear panel of
the printer, and disconnect the
printer parallel cable from the port.
Caution! When installing the NIC, take proper static control precautions to avoid damaging it. This area
also houses the optional memory expansion module (SIMM). Avoid touching the SIMM or controller board.
E F
Remove the two small
screws from the
expansion slot on the rear
of the printer and remove
the plate.
B
Top Cover
Release
Press the Top Cover Release
button and lift the Cover.
G
Carefully align the pins Connect the free end of the
and connect one end of interface cable to the
the interface cable to the connector on the controller
connector on the NIC. board.
C D
Remove the two screws
that hold on the
printer's side cover.
H
Align the NIC with the
expansion slot. Then,
reinstall and tighten the
two small screws
removed in step E to
firmly attach the NIC to
the printer.
Remove the side cover by
pulling it out and then up.
[PENDING
Mounting Bracket
plus 1 or 2 screws???]
To finish, replace
the side cover.
Reinstall and
tighten the screws
you removed in
step C . Then, close
the Top Cover of
the printer.