Table of Contents
Advertisement
5.
IEEE 1394a port connector (10-1 pin IE1394_2)
This connector is for a IEEE 1394a port. Connect the IEEE 1394a module
cable to this connector, then install the module to a slot opening at the back
of the system chassis.
BLITZ FORMULA
BLITZ FORMULA IEEE 1394a connector
Never connect a USB cable to the IEEE 1394a connector. Doing so will damage
the motherboard!
You can connect the 1394 cable to ASUS Q-Connector (1394, red) first, and
then install the Q-Connector (1394) to the 1394 connector onboard.
6.
Thermal sensor cable connectors (2-pin OPT_TEMP1/2)
These connectors are for temperature monitoring. Connect the thermal
sensor cables to these connectors and place the other ends to the devices
which you want to monitor temperature. The optional fan1~2 can work with
the temperature sensors for a better cooling effect.
BLITZ FORMULA
BLITZ FORMULA Thermal sensor cable connectors
Remove the thermal sensor cable from the assigned device when you set the
South Bridge Sensor Select item in BIOS to [SB Overheat Protection]. Refer
to page 4-31 for details.
The thermal sensor cable is purchased separately.
ROG Blitz Formula
IE1394_2
PIN 1
OPT_TEMP2
OPT_TEMP1
Temperature
Ground
2-35
Advertisement
Table of Contents
