1.
Disk enclosure
Eight disk drive blanks (may come pre-installed
2.
in enclosure)
3.
–04 brackets (not used)
4.
Pins for round-hole cabinet conversion
Figure 5 Kit contents
.
Converting the rails
The rail kit supplied with the disk enclosure comes configured for square-hole racks. If you need to
convert the rails for a round-hole racks, perform the following steps:
IMPORTANT:
Do not remove the pins from the ends of the rails unless you are converting the rails for use in
round-hole racks. These load-bearing pins are designed to fit through the holes without being removed.
1.
Locate the bag of eight round-hole pins included in the rail kit.
14
Installing disk enclosures into the expansion rack
5.
Rails with –03 brackets
6.
Two Fibre Channel copper cables
7.
Two enclosure power cords