Preparing The Expansion Rack For Connection To The Main Rack; Physically Inspect The Expansion Rack; Inspect Expansion Rack Disk Drives - HP 6400/8400 Reference Manual
Enterprise virtual array expansion rack
Hide thumbs
Also See for 6400/8400:
- User manual (408 pages) ,
- Software manual (86 pages) ,
- Installation instructions manual (15 pages)
Table of Contents
Advertisement
3.
Using 0.41m Fiber Channel copper cables, connect the disk enclosures in the third loop:
a.
Connect P2 (I/O-A) on S-25 to P1 (I/O-A) on S-26.
b.
Connect P2 (I/O-A) on S-26 to P1 (I/O-A) on S-27.
c.
Connect P2 (I/O-B) on S-25 to P1 (I/O-B) on S-26.
d.
Connect P2 (I/O-B) on S-26 to P1 (I/O-B) on S-27.
4.
Connect the rack power distribution units to a power source.
5.
Using a power cord provided in your kit, plug one end into a disk enclosure power supply and
the other end into a rack power distribution module. Plug the left power supply into the left module
and the right power supply into the right module.
6.
Repeat
Step 5
7.
Power on the rack distribution units.
8.
Press and hold the power push button (located at the rear of the disk enclosure) long enough to
power up the disk enclosure.
9.
Repeat
Step 8
Preparing the expansion rack for connection to the main rack
This section contains the preparation steps that must be performed before connecting the expansion
rack and the main rack.
Physically inspect the expansion rack
Physically inspect the expansion rack. Verifying each of the following conditions:
All enclosures and enclosure modules are properly installed and seated.
Each power supply is connected to one of the electrical outlets in the rack.
The end connector of each cable is plugged into a disk enclosure I/O module.
Inspect expansion rack disk drives
After the expansion rack is powered up, ensure that all disk drives are fully engaged and seated in
their associated enclosures. Observe the disk drive status indicators to ensure that the disks are working
properly. The status indicators will be amber or blue depending on the condition of the disk enclosure.
See
Figure 20
26
Installing disk enclosures into the expansion rack
for each disk enclosure in the expansion rack.
for each disk enclosure in the expansion rack.
for the location of the disk drive indicators and
Table 3
for a description of the indicators.
Advertisement
Table of Contents
