Brother CP-1800 User Manual page 7

Position of the wall-mounting bar in relation to the copyboard
2
Using a 5/16 in. (8 mm) drill bit, drill a hole at each point marked on the
wall.
3
Insert one of the enclosed anchors into each hole, and then push it into
the wall until the teeth on the rim firmly grip the wall.
4
Tighten each screw (by turning it clockwise)
approximately 20 turns.
a
The screws must be tightened by hand.
Do not use an electric screwdriver,
otherwise the copyboard may fall down.
10.2 in.
(259 mm)
10.2 in.
(259 mm)
1.9 in.
(48 mm)
36.7 in.
(932 mm)
PUSH
2. Setup
5