Brother CP-2000 User Manual page 14

2. Setup
5
To switch between vertical and horizontal mounting, attach the printer
to a different edge of the copyboard.
a.
b.
c.
d.
6
While holding both sides of the copyboard, hook the brackets at the
back of the copyboard onto the wall-mounting bar pegs.
a
12
Loosen the screws on the printer cable plug, and then remove the plug.
While holding the copyboard to prevent it from falling, remove the four
knobs used to attach the printer.
Place the printer on the other edge of the copyboard (either the bottom or
the right side as seen from the back of the copyboard), and then attach the
printer by installing the knobs.
+
Remove the seals covering the mounting holes that you will use to
install the printer, and then affix the removed seals to cover unused
mounting holes. Additional seals are enclosed if the original seals
become lost or damaged.
Reconnect the printer cable plug and tighten its screws.
Do not release the copyboard until you are sure that it is securely mounted
on the wall-mounting bar, otherwise the copyboard may fall down.