Brother CP-2000 User Manual page 7

3
Align the screws on the knobs with the holes in the brackets, and then
tighten each knob (one on each side).
+
While tightening each knob, it may be necessary to lift up the lower leg
slightly so that the screw on the knob correctly enters the hole in the
bracket.
4
Carefully lift up the copyboard to set it
up on its stand, and then spread the
legs completely.
a
To reduce the risk of the copyboard
falling down and causing injuries, do
not loosen the knobs on the stand
when the stand is in use.
5
Turn the adjuster on the end of each
back leg until the stand is stable.
a
To reduce the risk of the copyboard
falling down and causing injuries, be
careful that the copyboard does not
tip over.
2. Setup
5