Epson PP-100N - Discproducer - DVD Duplicator x2 User Manual page 68

Input Stacker
Output Stacker
Label Type
Color/Black
Quality/
Speed
Mode
High Speed
Setting
(Bidirectional
printing)
Color
Settings
Label Size
Copies
Ink Levels
Drying Time
Print Preview
68
Allows you to select the stacker where the blank discs are set.
Allows you to select the stacker to which to output published discs.
Allows you to select the type of disc label to be printed.
Select [Color] to print in color, and select [Black] for monochrome printing.
Quality: Print quality is the priority.
Speed: Printing speed is the priority.
If you check this, the printing speed increases because it prints when the
print head is moving either left or right.
Uncheck this to print in a single direction, which improves the print quality.
However, the printing speed slows down.
Click this to display the [Color Settings] screen (see page 127 in this guide).
Allows you to set the print colors.
Allows you to select from among the following label sizes from commercially
available software.
• Standard: Outside Diameter 116.0 mm, Inside Diameter 45.0 mm
• Wide: Outside Diameter 116.0 mm, Inside Diameter 25.5 mm
• User defined label size: Allows you to set a custom size
Allows you to specify the number of copies to print. The maximum number
of copies you can specify differs depending on the set Publish Mode.
Shows the approximate level of ink remaining in the ink cartridges.
Allows you to set the time it takes to dry the ink on the discs in the printer tray
after label printing is finished.
Select this checkbox to confirm an image of the printing results on screen
before printing when you print from commercially available software.