D-Link DSN-3200-20 - Xstack 8X1GBE Iscsi San Array 15 Bays 3U Quick Installation Manual page 12

1
Insert an Ethernet crossover cable
into the management port of the
DSN-3000 series and connect the
other end to your management
system's open Ethernet port (the one
set to IP address 192.168.1.2).
Note: The management port of the
DSN-3000 series does not support
MDI and will require a crossover
cable. Or if you wish, two standard
straight-through cables may be used
with an intermediate switch or hub.
The management port is 100MbE.
2
Insert an Ethernet cable into the
10GbE Host Network Connection of
the DSN-3000 series as identified
on page 7 and the other end to the
10GbE port of your SAN network.
3
Insert each of the three power cables
into the power supply as shown
below. And then plug the other end
of these power cables into a reliable
filtered power source such as a UPS
(Uninterruptible Power Supply).
Proceed to Software Installation Overview for the
DSN-3000 series.
12
Installing the DSN-3400
D-Link DSN-3200/3400 Installation Guide