A.2
Installing Memory
The xStack Storage Array provides four memory sockets:
Two sockets (J36 and J37) are for buffer/cache memory
Two sockets (J38 and J39) are for system memory
System Memory: The xStack Storage controller can address up to 2GB of system memory, but
only 512MB are required for operation of your controller. Your controller will have come
standard with at least 512MB (2 x 256MB modules) making upgrading of system memory not
necessary. Please see Figure A-6 system memory location.
Buffer (Cache) Memory: The xStack Storage controller can address up to 2GB of buffer
memory, and comes standard with at least 512MB (2 x 256MB modules) installed. This should
work well for most applications. However, several applications (such as video streaming) of
the product could benefit from increased cache memory. Please see Figure A-6 for buffer
memory location. Note on Memory: The xStack Storage controller's system and buffer
memory must be installed as matching pairs. Table A-1 lists the specifications for DIMMs
supported by the xStack Storage Array. These memory module specifications are crucial to
the operation of your SAN array. Please visit the
modules.
Table A-2 shows the possible memory configurations for your xStack Storage controller.
Please note that you must use matching memory modules for DIMM0 & DIMM1 as well as
matching memory modules for DIMM2 & DIMM3.
32
Appendix A Replacing and Upgrading FRUs
Figure A-6 Buffer and System Memory Location
www.dlink.com
website for tested memory