HP 2530p - EliteBook - Core 2 Duo 2.13 GHz Maintenance And Service Manual page 84

12. If it is necessary to replace the display bezel, remove the four rubber screw covers (1) and the
four Torx T8M2.5×6.0 screws (2) that secure the display bezel to the display assembly.
NOTE:
screw covers on the display bezel bottom edge.
13. Flex the inside edges of the bottom (1), left and right sides (2), and the top (3) of the display
bezel until the bezel disengages from the display enclosure.
14. Remove the display bezel (4).
NOTE:
bezel, and reapply adhesive before replacing the bezel.
15. If it is necessary to replace the display hinges, remove the two Phillips PM2.5×4.0 screws (1)
that secure the display panel to the display enclosure.
16. Disconnect the display passthrough board and camera passthrough board cables (2).
76 Chapter 4 Removal and replacement procedures
The rubber screw covers on the display bezel top edge are thicker than the rubber
Remove excess adhesive from the bezel and display enclosure when you remove the