Appendix A: Specifications
Configuring FWH Programming
Jumper block J4A1 allows you to set the FWH programming at 12 Volts. By default, FWH
programming is configured for 3.3 Volts.
Jumper diagram labeled:
A.
FWH Programming at 12 Volts
B.
FWH Programming at 3.3 Volts (Default Setting)
Configuring Recovery Boot
Jumper block J7A1 controls whether the system attempts to boot using the BIOS programmed in flash
memory. By default, the system does not perform a recovery boot using this BIOS.
Jumper diagram labels:
A. Default Setting
B. Use the BIOS Programmed in Flash Memory During a Recovery Boot
Procedure
1
J4A1
A
Figure A-16. Configuring FWH Programming
J7A1
1
A
Figure A-17. Configuring the Recovery Boot Process
1
J4A1
B
J7A1
1
B
178