Installing A Non-Hot Plug Pci Board - HP Integrity rx4610 User Manual

Chapter 7: Installing Accessory Boards
Figure 7-2. Open the PCI PHP Mechanism Securing the Board at the Rear of the Chassis
10. If you are adding a new board, remove the perforated rear panel cover in the slot you're using
by pushing it out from inside the chassis.
11. Press the PCI board down firmly until it seats in its slot.
CAUTION
12. Close the plastic latching mechanism that secures the end of the board nearest the front of the
chassis.
13. Rotate the PHP mechanism near the rear of the chassis up until it clicks into place. This
position both secures the end of the board and allows it to be activated with the operating
system or GUI application.
14. Close the rear part of the top cover and tighten the two thumbscrews.
15. Connect any required cabling to the add-in board.
16. If your server is operating, use the operating system or GUI application to power up the PCI
I/O slot into which you installed the PCI I/O board.
17. Push the system back into the equipment rack.

Installing a Non-Hot Plug PCI Board

Use this procedure to install a non-hot plug PCI accessory board. Observe the safety guidelines listed
earlier. The server must be shut down before installing a non-hot plug PCI board.
1. If the HP Server is already installed and working, power down the HP Server.
Some accessory/option board outputs exceed Class 2 or limited power source
limits and must use appropriate interconnecting cabling in accordance with the
national electric code during installation.
60