Table of Contents
Advertisement
Setting routes and route navigation
Set destinations and conduct route searches
Set destinations and search routes
Set destinations from the screen for setting destinations.
1
2
• Besides <Calling up maps>, it is possible to set up
destinations by scrolling maps manually on the scrolling
map screen and moving the cursor
this case, select
In this case, maps larger than 1:100,000-scale map should be
used.
• If the destination is located on express ways or in places
where it is impossible to enter, the following messages will
appear.
If you wish to set the destination at the place, select
, and if another road will be the destination,
select
• If a route search is conducted on an express way or a toll road, routes from the nearby open
road can be searched. In such cases, conduct a route search again. (see page 46)
• If one or more destination have already been set, the
following message will appear.
In order to clear the destinations that have already been
set and set a new destination, select
to keep the destinations that have already been set and set
additional destinations, select
• Select
become movable.
• Details of facilities are only displayed when maps are called up by the ways described in the
previous page.
• Details of facilities are not displayed in some cases.
Place the cursor at the point for the destination, and
select
<Calling up maps> (see page 17) is convenient to use.
Select
Destinations will set at the points of the cursor
mark
on the scrolling map screen.
.
for the map where the object is difficult to pinpoint in the search, and the cursor
.
.
and route searching will begin.
to the destination. In
. In order
.
using
25
English |
Advertisement
Table of Contents
