Table of Contents
Advertisement
• To write an END-ID on a recorded tape
•
If a tape was stopped at the end of a recording without writing an END-ID, you can use
the following procedure to write the necessary END-ID.
Play the tape and press
the ISTOPI button at the
end of the recording.
Verify that the'total elapsed
time is still shown on the
display.
I
Display example
""
u j
,-' =' · C
II
'_I'_ILI
Set the unit to
'~iliC:::
,oc:::: ::,,'
the AID converter at-
tached and with nothing
connected to the
[D[G[-
TAL [/0] jack.
~
Press the IFF/CUE] button
for at least 2 seconds.
•
After the END-[D is writ-
ten, the tape automati-
cally stops.
Press for at
least 2 seconds.
'-
~
i'l-
I
'I"
leI
""
L' -,
' - I
=1:5 5
While END-ID is written
(Stop mode)
•
Leave at least 9 seconds between the last ST-ID and the END-ID.
• To continue recording from the END-ID position
•
When you want to continue recording on a tape which contains an END-ID, you can use
the following procedure to continue the recording without interruption.
Press the
IFF/CUE] button.
(The tape stops auto-
matically right before
the END-ID.)
(Stops automatically)
""
U::::"
,_, ='·C C
'_"..J_'
•
[f the next recording is started using this procedure, the END-[D is erased automatically.
Tune numbers are automatically continued in sequence, and the total elapsed time is automati-
cally continued from the previous recording.
26
DX-7
Advertisement
Table of Contents
