Setting Up; Connecting The Pads - Yamaha DTX900 Owner's Manual

Setting Up

You'll need to change the Trigger Settings of the DTX900 according to the type of drum set you are using (Stan-
dard Set/Special Set/Acoustic Drums, etc.). If the setting is not appropriate, problems may occur—such as
improper sound, or inappropriate volume balance among the pads. Refer to the "Selecting the Trigger Setup"
section on page 22 on how to select the appropriate setup.

Connecting the Pads

Referring to the illustration below, connect the output cable from each pad to each Trigger Input jack located on the rear
panel of the DTX900. All Trigger Input jacks are conveniently labeled (1 SNARE, etc.), so make sure each pad is connected
to its corresponding Trigger Input jack.
WARNING
• To prevent electric shock and damage to the devices, make sure the power is switched OFF on the DTX900 and all
related devices before making any connections to the DTX900's input and output jacks.
■
DTX900K
DTX900
Module stand
(included)
Module stand fastening
screws x 4 (included)
to 9HI-HAT
to HI-HAT
CONTROL
* First, connect the RHH135's
[PAD] output jack to the 9HI-
HAT jack on the DTX900,
then connect the RHH135's
[HI-HAT CONTROL] output
jack to the HI-HAT CON-
TROL jack on the DTX900.
16
DTX900 Owner's Manual
IMPORTANT
Attaching the module stand
Attach the included module stand to the
DTX900 using the module stand fastening
screws.
* Be sure to use the included screws.
PCY135
DTX900
XP100T
RHH135
XP120SD
to 1SNARE
NOTE
• The pad models described in the illustrations were
included in the Standard Set/Special Set at the moment
this Owner's Manual was produced. Keep in mind that the
model names of your Standard Set or Special Set may be
different from the ones illustrated here. For details about
the latest information on Yamaha drum pads, refer to the
following website.
http://www.yamaha.co.jp/english/product/drums/ed/
to 7CRASH
to 2TOM1 to 3TOM2
XP100T
KP125W
* Foot pedal is not included
in the Standard Set.
to JKICK/K
to 6RIDE
PCY155
PCY135
to 8CRASH2
XP100T
to 4TOM3