e.
Hard drive (see
f.
Display assembly (see
Display assembly on computers with 14-in displays on page
g.
Top cover (see
Remove the USB connector assembly:
1.
Position the computer right-side up with the right side toward you.
2.
Disconnect the cable from the system board (1) and remove the cable from the routing path in the
base enclosure (2).
3.
Remove the Phillips PM2.5×3.0 screw (3) and the Phillips PM2.5×7.0 screw (4) that secure the
USB connector assembly to the base enclosure.
4.
Remove the USB connector assembly (5) from the base enclosure.
Reverse this procedure to install the USB connector assembly.
Hard drive on page
78)
Display assembly on computers with 15-in displays on page 84
Top cover on page
90)
97)
Component replacement procedures 105
or