Installing the airflow guide (Z400 only)
1.
Follow the procedures described in
workstation for component installation.
2.
Press the power cables, including P1, down toward the system board between the DIMM slots and
the internal bay, as shown in the following figure.
Figure 7-3
3.
Set the airflow guide into the chassis.
a.
Place the edge of the airflow guide (1) between DIMM socket #6 and the CPU heatsink.
Figure 7-4
b.
Route the power and data cables through the opening next to the internal bay (2).
ENWW
Positioning the chassis cables
Installing the airflow guide
Preparing for component installation on page 40
Installing the airflow guide (Z400 only)
to prepare the
47