Setting Up Fec In Netware; Teaming Options Supported By Os And Protocol - HP D5970A - NetServer - LCII Installation Manual

Chapter 8
Deleting a Team
1. Double-click the Network icon in Control Panel.
2. On the Adapters tab, select the FEC team to delete.
3. Click Remove. A confirmation dialog box appears. Click
Yes.
4. Click Close. Restart when prompted.
NOTE
When IPX is used, the frame type for each
adapter in the team reverts to Auto when a
team is deleted. You may need to set it to the
specific frame type to connect to your
network.

Setting up FEC in NetWare

To set up FEC in NetWare, use the instructions in the Setting
up Adapter Fault Tolerance in NetWare section earlier in this
guide, substituting "FEC" for the "Z" parameter.
Teaming Options Supported by OS and
Protocol
Windows NT 4.0
AFT IP, NetBEUI, IPX(NCP),
IPX (NetBIOS)
IP, IPX (NCP)
ALB
IP, NetBEUI, IPX (NCP),
FEC
IPX (NetBIOS)
Note that only IPX packets type NCP (NetWare Core Protocol)
are load balanced. Under FEC, all protocols can be load
balanced.
36
Choosing Adapter Teaming Options
NetWare 4.2, 5.0, 5.1
IP, IPX (NCP),
AppleTalk
IP, IPX (NCP)
IP, IPX (NCP)