Fdd (Flexible Disk Drive Or Floppy) Tests - HP D6030A - NetServer - E50 User Manual

Chapter 5

FDD (Flexible Disk Drive or Floppy) Tests

Flexible Disk Drives are tested for rotational speed, elevator, and seek channel.
Code Description
0301h Undefined or
invalid command.
0302h DiagTools Error
0303h DiagTools Error
0304h DiagTools Error
0305h Reset failed.
DiagTools issued a
reset command and
it was not accepted
or confirmed by the
floppy disk
controller.
0307h Drive parameter
activity failed.
0308h DMA Overrun
error.
0309h Attempt to DMA at
64 KB boundary.
030Ah DiagTools Error
0310h Floppy CRC or
ECC data error.
0311h DiagTools Error
0321h The circuit that
detects changed
diskettes is not
working.
Recommended Action
1. Try a different diskette.
2. Check the cable between the floppy drive and the system board.
3. Change the floppy drive.
4. Change the system board.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
1. Try a different diskette.
2. Check the cable between the floppy drive and the system board.
3. Change the floppy drive.
4. Change the system board.
1. Try a different diskette.
2. Check the cable between the floppy and the system board.
3. Change the floppy drive.
4. Change the system board.
1. Try a different diskette.
2. Check the cable between the floppy and the system board.
3. Change the floppy drive.
4. Change the system board.
1. Try a different diskette.
2. Check the cable between the floppy and the system board.
3. Change the floppy drive.
4. Change the system board.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
1. Try a different diskette.
2. Check the cable between the floppy drive and the system board.
3. Change the floppy drive.
4. Change the system board.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
1. Try a different diskette.
2. Check the cable between the floppy drive and the system board.
3. Change the floppy drive.
4. Change the system board.
Error Message Reference
49