Multiprocessor Test - HP D6030A - NetServer - E50 User Manual

Chapter 5
Code Description
Drive x in Sector y.
0A06h Random data test
failed. No CD in
drive.
0A07h DiagTools Error
0A08h DiagTools Error
0A09h DiagTools Error
0A10h DiagTools Error
0A11h Data Integrity test
failed.
0A12h DiagTools Error
0C01h DiagTools Error
0C02h DiagTools Error
0C03h DiagTools Error
0C04h DiagTools Error
0C05h DiagTools Error
0C06h DiagTools Error
0C07h DiagTools Error

Multiprocessor Test

This test works on Multiprocessor systems only. This test detects all the processors in the system
and then checks if all the processors are able to communicate among themselves. It also checks
ability to access the system memory and devices concurrently.
Code Description
1000h Multi Processor
Failure. Processors
don't have unique
IDs.
60
Recommended Action
2. Check the cable between the CD and its controller.
3. Change the CD drive.
4. Change the board where the controller for the CD drive is located.
1. Insert a data CD in the drive.
2. Check the cable between the CD and its controller.
3. Change the CD drive.
4. Change the board where the controller for the CD drive is located.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
1. Insert a different data CD in the drive.
2. Check the cable between the CD and its controller.
3. Change the CD drive.
4. Change the board where the controller for the CD drive is located.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Recommended Action
1. Reduce the system to its minimum configuration per the technical reference
label or card.
2. Make sure the system board is seated.
3. Check the seating of the voltage regulator module (VRM) if present.
Error Message Reference