Installing Replica For Netware; What You Need - HP D6030A - NetServer - E50 Getting Started

Chapter 3
9. Click the Continue button.
10. When the installation is complete, click Close to exit Tape Device Setup,
then close the Setup utility.
11. Shut down Windows NT and reboot the HP NetServer.
Installing Replica on Windows NT 3.51
After you have installed the T4 driver on your Windows NT 3.51 system, you can
install Replica.
To install Replica:
1. Insert the Stac Replica Backup HP SureStore Tape Edition CD-ROM in
the HP NetServer CD-ROM drive.
2. Execute the SETUP.EXE file stored in the \stac directory.
3. Once the Setup utility is running, follow the on-screen instructions for
completing the installation.
When the HP NetServer restarts, Replica is ready for use with the HP
SureStore tape drive.

Installing Replica for NetWare

This section provides instructions for installing Replica and its related files on an
HP NetServer running NetWare, or another Novell network operating system.
NOTE
For best results, always close any applications running on the
HP NetServer before starting the Replica installation.

What You Need

Before you can install Replica and begin backing up server files, you need the
following:
For the host server:
An HP NetServer running Novell NetWare 3.12 or 4.1x
At least 16 MB RAM
At least 5 MB free disk space in the SYS volume
8
Installing Replica