Step 2: Unlock And Remove Front Bezel; Step 3: Remove Cover 1 And Cover Plate - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 2
3. Turn off power to the HP NetServer.
4. Disconnect the AC power cords and all external cables from the
HP NetServer.
WARNING
Before removing the cover, always disconnect the power
cord(s) and unplug telephone cables. Disconnect telephone
cables to avoid exposure to shock hazard from telephone
ringing voltages. Disconnect the power cord(s) to avoid
exposure to high energy levels that may cause burns when
parts are short-circuited by metal objects such as tools or
jewelry.
Note that the power switch does NOT turn off the standby
power. Disconnect the power cord(s) to turn off standby
power. If the backlight on the front panel LCD is still on,
standby power is still on.

Step 2: Unlock and Remove Front Bezel

To unlock and remove the front bezel, refer to the guides listed below that apply
to your HP NetServer configuration:
HP NetServer LH 3000/3000r Installation Guide
HP NetServer LH 6000/6000r Installation Guide
The Installation Guide for Compaq
NetServer

Step 3: Remove Cover 1 and Cover Plate

WARNING If the HP NetServer is installed in a rack, extend the anti-tip
foot or attach the anti-tip feature before extending the
HP NetServer from the rack. Also lower the leveler feet of the
rack to improve stability and to prevent the rack from rolling.
Failure to use the anti-tip foot or feature and the leveler feet
could result in serious injury.
1. If the HP NetServer is installed in a rack, extend the HP NetServer from
the rack. Refer to your HP NetServer installation guide for instructions.
8
®
4000/7000 Racks for your HP
Installation