Prepare Drive For Installation; Introduction; General Installation Steps - HP D7171A - NetServer - LPr Installation Manual

1 Prepare Drive for Installation

Introduction

This chapter describes the tools, setup information and the steps necessary to
install a SCSI hard disk drive into an HP NetServer. The drives documented in this
guide are listed in Table 1-1.
Table 1-1. Hard Disk Drive Product Numbers
HP Product Number
D4910A
D4911A

General Installation Steps

In general, the steps for installing a hard drive are shown below. Please refer to the
detailed instructions in each step before attempting to install your drive.
1. Prepare for Installation
2. Determine the Drive Type
3. Set the SCSI Address
4. Connect SCSI Cable Adapter (if required)
5. Mount the Drive in the System
6. Connect the Drive Activity Light (if appropriate)
7. Connect the Drive
8. Configure the Drive
CAUTION In a few cases, drives with the same product number can be of
different types and require different jumper settings. If your
drive does not match the type in the figure, check the other
figures for the matching type.
1
The operating system may report a different capacity.
1
Capacity
4.26 GB
9.10 GB
1