Removing The Terminator Board - HP D7171A - NetServer - LPr Installation Manual

Chapter 1

Removing the Terminator Board

If your system has one processor, a terminator board is installed in the upper slot.
You must remove the terminator board before installing a processor module into
this slot. (See Figure 1-10).
1. Squeeze together the two retaining latches on the terminator board.
2. Pull the terminator board out of the socket.
Save the terminator board for future use.
Figure 1-10. Removing the Terminator Board
12
Processor Module Installation
Terminator Board
Terminator Board
Retaining Latches