HP D7171A - NetServer - LPr Installation Manual page 15

Chapter 3
2. Place the mounting flange of the slide between the inside of the column
and the bar nut. See Figure 3-4. Do this at the front and rear of the slide.
Figure 3-4. Mounting a Slide to a Column
3. If your slide has the dimple shown in Figure 3-3, center the dimple in the
square hole on the rack column.
4. Press the slide firmly against the screws. Lift up against the screws.
5. While lifting the slide, tighten all four screws to secure the slide.
NOTE
It is very important to lift up on the slides prior to tightening
6. Repeat for the other slide.
the screws. Tightening the screws without lifting up on the
slides will result in interference between the HP NetServer
and other equipment in the rack; you may not be able to slide
the HP NetServer into the rack enclosure after completing the
installation.
Installation
Push In and Up
11