HP D7171A - NetServer - LPr Installation Manual page 21

Chapter 3
3. Install the two 6-32 pin head Torx T-15 screws in the two threaded holes
on the rear of the NetServer.
4. Orient the cable management arm as shown in Figure 3-8.
5. Install the flange over the 6-32 screws and tighten them.
6. Attach the other flange of the cable arm to the rear column of the rack with
the two M-6 pan head Phillips screws, included with the arm.
WARNING
Before sliding out the HP NetServer, ensure that the anti-tip
foot is still extended from the front of the rack, or the anti-tip
feature is installed, and that the leveler feet are lowered. A
tip over hazard exists, so never slide more than one
component out of the rack at a time.
7. Extend the HP NetServer out of the rack to ensure that the cable
management arm moves with the chassis without binding.
8. Slide the HP NetServer back into the rack.
9. At the front of the rack, insert the screws through the flanges into the rack
nuts and secure the HP NetServer to the front rack columns.
Each of the HP NetServer's two front flanges has two slots, which should
line up with the rack nuts previously mounted on the rack columns.
10. Plug the HP NetServer's power cable and all available data cables into the
back of the HP NetServer.
Refer to the rack assembly and cabling reference guide for your
HP NetServer, for information about cable dressing and routing.
Installation
17