HP D7171A - NetServer - LPr Installation Manual page 18

Srom=alad(0,0,5,0)
for the NetServer E 30, E 40, E 45, E 50, LC II, LC 3 or LH 3 running
OpenServer 5.0.0 or 5.0.2 type:
restart link="amird wd" Sdsk=amird(0,0,0,0)
Srom=wd(1,0,0,0)
for the NetServer E 30, E 40, E 45, E 50, LC II, LC 3 or LH 3 running
OpenServer 5.0.4 type:
restart link=amird Sdsk=amird(0,0,0,0)
Srom=wd(1,0,0,0)
for the NetServer E 60 running OpenServer 5.0.5 type:
restart disable=alad link=amird Sdsk=amird(0,0,0,0)
Srom=wd(0,0,0,0)
4. There is a bug in the OpenServer 5.0.4 Installation Query Manager which may make
phantom disks appear at the point where you are configuring the file systems on the
disks. Until SCO fixes this problem you are advised to "defer" configuring all disks
except the root disk until after the system is fully installed. Your additional disks and
filesystems can be configured using "mkdev" after the system is installed.
5. There is another bug in OpenServer 5.0.4 where multi-processor systems using the
"alad" driver and SCO ArcServer Lite will hang during system boot. SCO is working
on a new "alad" driver to fix this problem.
6. Follow the instructions in the SCO Installation and Upgrade Guide to complete your
system installation.
Apply SCO SLS OSS452A Kernel Mode Trap Type 0x0000000F Patch
For OpenServer 5.0.0 and 5.0.2, SCO has found a problem with some Pentium Pro
machines that are capable of running multiple CPUs but only have a single CPU
installed. In some cases the system will panic with the panic message:
PANIC: k_trap
SCO has releases a patch that will prevent the system from panicing. Install SCO SLS
OSS452A (or later) which is available from SCO's ftp site. Follow the instructions in the
file oss452a.ltr on how to apply the patch.
This fix has been incorporated into OpenServer 5.0.4.
kernel mode trap type 0x0000000F