Install Additional Memory - HP D7171A - NetServer - LPr Installation

4

Install Additional Memory

Use HP DIMMs listed on the Technical Information
Label on top of the chassis.
1. Remove the processor board.
2. Align the notches on the DIMM with the keys on
the socket.
3. Insert the DIMM until the retaining clips snap
into place.
4. Reinstall the board.
5 Install Additional EISA Boards
and PCI Boards
NOTE Do not install ISA boards until instructed by the
Configuration Assistant program in Step :
Configure the HP NetServer and Install Additional
ISA Boards.
1. Read the documentation included with each board. Look
for any special instructions and refer to the Accessory
Board Installation Recommendations.
2. If necessary, remove the board retainer.
3. Remove the slot cover for each slot used.
Boards can be identified by the shape of their connectors:
Technical
Information
Label with DIMM
part numbers
8
Technical
Information
Label
PCI Bus 0
PCI Bus 1
Board
Retainer
ISA
EISA/ISA Bus
PCI
EISA
Notches
Install DIMMS:
• in any order
• in any socket
Accessory Board Installation Recommendations
Install the optimal PCI performance board (either Network Interface Card or
SCSI controller) in PCI 9.
Install the EISA SCSI controller in slot 1 to ease the routing of cables.
Boot device priority order :
CD-ROM drive with bootable CD-ROM
Flexible disk drive with bootable flexible disk
IDE drive
EISA or ISA controller set to BIOS address C8000 (To boot from an EISA or
ISA controller, set the BIOS address to C8000. Other controllers must have
BIOS disabled or addresses set at the end of the D0000 range.)
PCI controller (embedded SCSI A, embedded SCSI B, PCI slots in the
following order: 9, 8, 7, 6, and 5. The PCI boot priority order can be changed
so that PCI slots precede SCSI A and SCSI B.
Set BIOS addresses, disable BIOSes and change PCI boot priority order
using the EISA Configuration Utility in Step 8: "Configure the HP NetServer
and Install Additional ISA Boards."
For a complete description of the boot device priority order, see Information
Assistant on the HP NetServer Navigator CD-ROM.
CPU
PCI 9
PCI 8
PCI 7
PCI 6
PCI 5
E5
E4
E3
E2
E1
Keys