HP ProLiant DL320e User Manual page 36

Installation options
/romonly
/softwareonly
/express_install
Overriding errors
/tpmbypass or /ignore_tpm
/ignore_warnings
/continue_on_error <error>
/override_existing_connection
/On_failed_dependency: <parameter>
/partition_only
36 Using scripts to deploy updates
Description
This filter switch allows you to see only the firmware
components needed for installation. When you are using
this filter switch, you must exit and restart HP SUM if you
want to return to an unfiltered state.
Do not use the /romonly argument with the
/softwareonly argument. (Applies to firmware only.)
This filter switch allows you to see only the software
components needed for installation. When you are using
this filter switch, you must exit and restart HP SUM if you
want to return to an unfiltered state.
Do not use the /softwareonly argument with the
/romonly argument.
Starts an express installation (for the local host only). The
HP SUM performs discovery, installation, or exit without
user interaction. You can cancel or terminate HP SUM. An
express installation will force install all components in the
default repository and may downgrade drivers and
firmware to the versions in the default directory as part of
the installation operation. The express installation feature
allows you to set a baseline and enforce it regardless of
the currently installed version of drivers and firmware on
the local server.
Description
Specifies that if a TPM is enabled, the warning message
should be ignored and component installation can continue.
For more information about TPM, see
to permit firmware updates" (page
Allows the installation to proceed on a Superdome 2 target
even when warnings are returned during analysis.
Causes the installation to continue and ignore errors. Valid
values are as follows:
* <error>=ServerNotFound and
* <error>=BadPassword.
* <error>=FailedDependencies
You can use the ServerNotFound option to bypass
inactive or unavailable remote hosts when you are
deploying firmware or software to multiple remote hosts at
the same time.
Defines the behavior when a remote target has an existing
HP SUM session in progress. It overrides the session in
progress and re-initializes the installation framework on
the remote host.
Provides HP SUM <parameter> the information on how to
proceed when a component has a failed dependency. The
supported parameters for this argument are Omit_Host
(default), Omit_Component , and Force. Omit_Host
causes the host to be put into a failure state, and no
installation is attempted. Omit_Component deselects the
affected components and proceeds with any updates that
do not have dependency failures. Force attempts all
updates, even if they have dependency failures.
Use this argument to select a partition to update.
"Disabling BitLocker
12).