Cisco 4700M Administration Manual page 48

Setting Up the ACE
Detailed Steps
Command
Step 1
copy running-config startup-config
Example:
host1/Admin# copy running-config
startup-config
Step 2
reload
Example:
host1/Admin# reload
This command will reboot the system
Save configurations for all the contexts.
Save? [yes/no]: yes
Generating configuration....
running config of context Admin saved
Perform system reload. [yes/no]: [yes] yes
Using the GRUB Boot Loader to Specify the System Boot Image During a Reload
This section describes how to specify a value of 0x0 for the config-register command (see the
the Boot Method from the Configuration Register"
loader mode upon a reload or power cycle of the ACE. The ACE remains in GRUB boot loader mode
until you identify the location of an image file to boot.
Press Esc when the count down initiates on the GRUB boot loader. The following GRUB menu appears.
GNU GRUB
******************************************************************
* image(c4710ace-mz.A3_1_0.bin)
* image(c4710ace-mz.A1_8_0A.bin)
*
* ****************************************************************
In the GRUB menu, use the arrow keys to select from the ACE images loaded in the Flash memory. The
ACE image entry is highlighted in the list.
Perform one of the following actions:
•
•
•
If no ACE images are loaded in the Flash memory, the GNU GRUB multiboot loader appears as follows:
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-32
version 0.95 (639K lower / 3144640K upper memory)
Press enter to boot the selected software version.
Type e to edit the commands before booting.
Type c to access a command line.
Purpose
(Optional) Copies the running configuration to the startup
configuration.
Restarts the ACE and reloads the configuration. When you specify
reload, the ACE prompts you for confirmation and performs a
cold restart of the ACE.
During the reload process, the ACE performs one of the
following actions:
If you specified a value of 0x1 for the config-register
•
command (see the "Setting the Boot Method from the
Configuration Register"
image identified in the BOOT environment variable.
If you specified a value of 0x0 for the config-register
•
command, the ACE enters the GRUB boot loader mode and
you must identify the location of an image file to boot (see
the "Using the GRUB Boot Loader to Specify the System
Boot Image During a Reload"
section) to force the ACE to enter the GRUB boot
Chapter 1 Setting Up the ACE
section), the ACE boots the system
section).
*
*
OL-20823-01
"Setting
*