Table of Contents
Advertisement
Diagnostic Utility
When a device fails diagnostics, you should reset the BIOS and run that diagnostic test again to be sure
•
If any component fails diagnostics, the device should be sent in to the National Service Center for repair
•
g
y
Troubleshooting
Stop the test, press the grey STOP button
•
when the status light is blue.
when the status light is blue
You may need to press the stop button more
•
than once
To pick a specific peripheral or device to test,
•
click on that icon to enable it for testing
Peripherals or devices that are not enabled
Peripherals or devices that are not enabled
•
for testing will be grayed out
Peripherals or devices that are enabled for
•
testing will be shown in full color
g
g
24
g
Advertisement
Table of Contents
