Outdoor Model Installation; Preparing The Cabinet For Installation - Toro 53765 - Outdoor Ecxtra Sprinkler Timer User Manual

Outdoor Model Installation

B
R R
R

Preparing the Cabinet for Installation

1. Remove the lower housing cover (A) by pulling
outward on the handle.
2. Remove two phillips screws from the transformer
access cover (B). Pull the cover outward from the
bottom to remove.
3. Three lower mounting holes (C) are provided. The
center hole is open and the outer holes are plugged. If
you intend to use the outer holes for installation, care-
fully drill through the plugs with a 3/16" drill bit.
O N
O N
A
B C
M AN
M AN UA L
ST AR UA L
ST AR T
T
P R O
G R A N EX
M S N EX T
T
O FF
O FF
R
A
D
E
Four wiring access holes are provided in the cabinet base
as follows:
(D) - 1/2" for power and equipment ground wires.
(E) - 1/2" (plugged) for optional Toro Rain Sensor wires.
(F) - 3/4" for sprinkler valve wires.
(G) - 1/2" (plugged) for optional Toro remote control cable.
4. If planning to install the optional Toro components,
remove the plugs as necessary.
ON
MANUAL
NEXT
START
A B C
OFF
C
F
G
9